Sharpening

ProEdge Short Tool Rest

Designed for sharpening mini or midi size tools, the Robert Sorby® ProEdge™ Short Tool Rest is only 1" long preventing interference while sharpening.

ProEdge Small Knife Sharpening Jig

The jig consists of all parts required to convert a ProEdge, a new back plate, raised wear plate, universal arm and knife holder. The kit includes instructions on fitting and should only take a few minutes to fit onto the ProEdge. This small knife holder is for pocket knives, carving knives and blades up to 8" long . The clamp on the knife holder has three screws, two clamping screws and a jacking screw to enable different thickness of blades to be safely held. The adjustable collar on the arm will allow different bevel angles to be sharpened from a steep angle for a woodcarving knife to a shallow angle for a fish filleting knife.

Set Includes:

• A Small Knife Holder
• Back Plate
• Wear Plate
• Universal Arm
• Instructions.

ProEdge Large Knife Sharpening Jig

A simple and fast means of sharpening knives to a razor edge on your ProEdge System. For sharpening hunting knives and other blades over 8" long. The Knife Holders clamp blades securely across the Holder's full length. The adjustable collar on the Holder arm will allow different bevel settings to match the knife type - from a steep angle for carving knives to a shallow angle for a fish filleting knife.

Set Includes:

• A Large Knife Holder
• Back Plate
• Wear Plate
• Universal Arm
• Instructions.

Holders are also available separately so you can upgrade your existing set to to handle the opposite size just by adding the appropriate holder.

TurnMaster Tip Holder

his handy little sharpening accessory allows you to hold comfortably nearly every TurnMaster tip without fear of catching the cutting tip - or even more importantly, your finger - in a sharpening belt or grinding wheel.

Holder is just over 5-1/2" long.

The Holder has a narrow tip with a fastening screw that will hold your cutter at any angle so you can grind safely. The tip of the holder is narrow, so as not to get in the way.

Designed for the Sorby ProEdge Sharpening System

ProEdge Cutter Tip Holder

An inexpensive yet indispensable little sharpening accessory. It is double ended to allow you to hold comfortably almost every Sorby tool tip without fear of catching the cutting tip or, even more importantly, your finger, in a sharpening belt or grinding wheel. It avoids skinning fingers when sharpening.

Note: Cutters not included.

ProEdge Pigtail Mandrel

The ProEdge Pigtail Mandrel is used to mount the ProEdge Buffing Wheel (Mop) to belt drive pulley at the lower right of the sharpening system.

ProEdge Proset

For use with the Sorby ProEdge Sharpening System fingernail gouge profile jig. Sets the proper extension distance of the tool tip from the holder of the Fingernail Profile Jig. Ensures precise and repeatable bevel angles. England.

By placing the gouge into the clamp of the profile arm and then extending the gouge up to the required stop and locking it into place, this will allow for precise and repeatable bevel angles to be obtained.