This is one of the handiest
accessories ever for the drill press. If you use your drill
press to drum sand this is an absolute must. Adjust the
hose to any position you like and it will stay right where
you put it! Add on nozzles for any type of drill press
job! The Drill Press Dust Collector fits most standard
table and floor model Drill Presses. Some drill presses may require an extra link to extend
the nozzle tip closer to the dust source.
Complete Drill Press Dust Collector Kit
The kit comes
with 12” of Rigid Flex-Lock Hose, 1 each Drill Press Column Mounting Bracket ,
1 each . 2 1/2” hose adaptor, and 1 each. tapered nozzle.
No.
Description
Price
Quantity
351
Drill Press Dust
Collector Kit
$39.99
Drill
Press Dust Collector Accessories
Extra Hose and Nozzles
No.
Description
Price
Quantity
349
A-12" Rigid Flex Hose
$15.99
344
1 Extra Rigid Flex Hose Link (not shown)
$1.99
346
B-Round Nozzles
$6.99
348
C- Taper Nozzles
$6.99
347
D- Rectangle Nozzles
$6.99
Hose Not Included
Snap-In
2-1/2" Rigid Flex-Lock Adaptor
The adaptor snaps right on
to the Rigid Flex-Lock links witch then allows you to attach a
2 1/2" hose to it.
No.
Description
Price
Quantity
345
Snap-In
2-1/2" Rigid Flex-Lock Adaptor
$5.99
UHMW
Mounting Bracket
This mounting
bracket can be used to mount Rigid Flex - Lock Hose
to your drill press. The UHMW Mounting Bracket bolts to the drill press motor mounting bracket. Some 8" or 10" and some 12" benchtop models needs adapter plate #343 below.
No.
Description
Price
Quantity
350
UHMW Drill Press Dust Collector Mounting Bracket
$14.99
Drill
Press Dust Collector Adaptor Plate
The drill press dust collector adaptor
plate is used for drill presses that are to small to allow
the dust collection system to attach properly. It fits
directly on to the motor mount to project the setup outward
from the machine.
No.
Description
Price
Quantity
343
Drill Press Adaptor Plate
$5.99
4"
to 21/2" Reducer
4” to 2½” allows you to reduce
from a 4” hose down to a 2½” hose. Hose clamps are required
for this type of connection or the small end accepts a standard
2¼” Shop-
Vac® hose end. Only one hose clamp is required on the opposite
4” end for this type of connection.
No.
Description
Price
Quantity
441
4" To 2 1/2" Dust Collection Reducer
$3.99
2
1/2" Splice Fitting
Splice fittings are used simply
to connect two sections of dust collection hose together.
You can use them on long runs of hose line or short runs
of hose line. Hose clamps are required for proper connection
. The 2-1/2” fitting will accept a 2-1/4” Shop-Vac® hose.
This will allow you to join two Shop-Vac® hoses end to end
with no hose clamps.
